Notifier XP6-C Six Circuit Supervised Control Module and SYNC-1 Accessory Card
Notifier XP6-C six-circuit supervised control module provides intelligent alarm systems with supervised monitoring of wiring to load devices that require an external power supply to operate, such as horns, strobes, or bells.
Each module is intended for switching applications involving AC DC or audio, which require wiring supervision. Upon command from the control panel, the XP6-C will disconnect the supervision and connect the external power supply across the load device.
The first module is addressed from 01 to 154, while the remaining modules are automatically assigned to the next five higher addresses.
Each XP6-C module has terminals for connection to an external supply circuit for powering devices on its notification appliance circuit (NAC).
One or multiple power supplies or amplifiers may be used.
NOTE: Provisions are included for disabling a maximum of three unused addresses.
Each XP6-C module features a short-circuit-protection monitor to protect the external power supply against short-circuit conditions on the NAC.
When an alarm condition occurs, the relay that connects the external supply to the NAC will not be allowed to close if a short-circuit condition currently exists on the NAC. Additionally, an algorithm is incorporated to find shorts when the module is active.
The XP6-C module will close all circuits that are not shorted to find the NAC with the problem.
Each XP6-C module has panel-controlled green LED indicators. The panel can cause the LEDs to blink, latch on, or latch off.
The SYNC-1 accessory card provides the XP6-C with additional functionality with compatible System Sensor® SpectrAlert® and SpectrAlert Advance® audio/visual devices.
