Notifier LCD-160 640-character Liquid Crystal Display (LCD) annunciator and remote control for the NOTIFIER NFS-3030/NFS2-3030 Fire Alarm Control Panel (FACP)
The LCD-160 will mimic the top portion (160 characters) of the NFS-3030/ NFS2-3030’s 640-character display. This provides the event and preprogrammed custom messages as displayed on the main panel. The full screen contains soft key functions, and can display other panel information.
LCD-160 Features
• 640-character Liquid Crystal Display with backlit control.
• On-board input, output, and status indicators to support diagnostics.
• Software upgrades and foreign-languages character sets via serial port from a panel or other device using the Remote Data Port (RDP) interface. Upgrades do not require the replacement of any programmable devices.
• Rubberized keypad.
• Input for AKS-1B key switch.
• Fits in two ACS annunciator module locations.
• Display and Control Center (DCC) participation/indication.
RDP Interface
Any communication between the control panel and any RDP device, such as the LCD-160, occurs over an RDP interface.
• RDP interface communication is supervised by the FACP and the LCD-160.
• RDP bus can drive up to 32 RDP devices. The FACP must be at one end of the bus; the last RDP device on the circuit must have an enabled end-of-line resistor.
• Each LCD-160 on the bus requires a non-resettable 24 VDC power connection. The power circuit is inherently supervised and a loss of power registers as a communication failure at the control panel.
• The LCD-160 can be powered by a regulated remote power supply certified for fire-protective signaling use. If the 24 VDC power comes from a non-power-limited source, it must remain separate from the power-limited RDP bus.
Specifications
Input supply voltage (TB2): Regulated, filtered 24 VDC via non-resettable power supply interface certified for fire-protective signaling use. Sources can be: panels with integrated power supplies, main power supplies (AMPS-24, etc.), auxiliary power supplies (APS2-6R, etc.); or a compatible accessories output. If RDP devices are to be powered by separate power supplies, a common reference connection must be established.
Data communications port (TB1): Power-limited RDP interface.
Current draw: Standby current: 0.300 A with backlight on, 0.075 A with backlight off. Alarm current: 0.325 A with backlight on, all LEDs active.
FAQ
Which panels does the LCD-160 work with?
It is the remote annunciator for the NOTIFIER NFS-3030 and NFS2-3030 and mimics the top 160 characters of the panel’s 640-character display.
How does it connect to the panel?
Over the supervised RDP bus, which can drive up to 32 RDP devices. The panel must be at one end of the bus and the last device needs its end-of-line resistor enabled.
What power does it need?
A regulated, non-resettable 24 VDC source. Standby draw is 0.300 A with the backlight on and 0.075 A with it off.
Can it be locked out?
Yes. It has an input for the AKS-1B key switch.