The Gamewell-FCI Velociti® Series addressable monitor module AMM-2F is a single Style B, Class B initiating device circuit (IDC) with a 47KW end-of-line resistor
This module provides an address for any device or group of devices connected to this circuit on the signaling line circuit (SLC) of the Gamewell-FCI addressable series fire alarm control panel.
Any initiating device with normally open (N.O.) dry contacts may be addressable when connected to the AMM-2F module. The Velociti® Seriems use a communication protocol substantially increasing communication speed between the sensors and certain Gamewell-FCI analog addressable fire alarm controls. These devices operate in a grouped fashion.
If one of the devices in the group has a status change, the panel’s microprocessor stops the group poll and concentrates on the single device. The net effect is a response speed up to five times greater than earlier designs.
The AMM-2F module can be programmed to provide various input functions to the Gamewell-FCI addressable series fire alarm control panels. It can be identified as a manual station, heat detector, plenum detector, water flow switch, tamper switch, N.O. contact, smoke detector, projected beam smoke detector, sub-loop, remote zone, etc. It can also be a remote system silence, reset, acknowledgment, or drill switch.
Customizing its device type to meet specific job requirements is even possible. The initiating device circuit of the AMM-2F can support a maximum line resistance of up to 40 ohms, allowing linear heat detection devices to be used.
The compact size facilitates the installation of the module inside manual stations or mounting boxes of various types of alarm initiating devices.
Ordering Information AMM-2F: Addressable monitor module, single circuit, Style B, Class B
